Organised by: Building Services Technical Division, IEM
SYNOPSIS
In a building there are many services, among them the LEAST glamorous is the SANITRY system. This is expected because the sanitary system channels all the soil and waste out of the building to the external manhole, an effective method to ensure foul smell does not enter the building. Also the contract value is probably the lowest too because it relies on the gradient and gravity force to move the soil and waste inside the plastic pipes. Now a probable FACT Architects, Engineers and Interior Designers would focus on the LAYOUT ONLY and most likely leaving the detailing aspects to the Plumbing Contractor. This dependency could be the likely reason why our toilets often faced blockages within a short duration AND are smelly. To mask the smell it is common to see odorizer inside the toilet, a chemical compound which is carcinogenic now is a norm and acceptable. It adds cost to the maintenance of the toilets. The concept of Indoor Air Quality goes out of the window. An odorless toilet is possible if the concept of water seal is applied to ALL fittings and branch discharge pipes properly routed at the right gradient. Elbow must not be used without a drop of elevation!!!
Rainwater Harvesting (RWH) concept has been promoted to conserve treated water and it will CERTAINLY be possible if the collected rainwater is used for WC flushing, each flush saves 6 liters of treated water. The RWH concept can be done with a VERY SIMPLIFIED gravity feed concept that has minimum fittings and does not required the expensive “special” fittings. This is probably why the implementation of RWH did not take off even after all these years. It is possible to design and installed RWH system with minimum costs yet has the ability to have treated water as backup during the dry season AUTOMATICALLY and easily maintainable
SPEAKERS
Ir. GARY LIM ENG HWA BE(Mech.) NZ, Mgt Dip. FIEM, P.Eng, Asean Eng. AT31000 – Approved Trainer ISO31000
Ir Gary Lim is an experienced and qualified Professional Engineer with over 20 years of manufacturing experience in these areas; Industrial Engineering (Work Study), Project Management, Maintenance, Production and Factory Management. The 20 years of his work spanned over various industries namely industrial chemicals, diary products, jam, sauces, chocolates, confectionnaires, industrial gases (liquid nitrogen, oxygen, argon, etc), blow moulding of plastic containers and paint manufacturing (highly fire hazardous). In the diary industry involved in the design of Clean-In-Place (CIP) system of the process pipings.
Gary had conducted numerous risk management surveys of various industries from wafer plant to power plants. Currently, a council member and committee member of the Building Services Technical Division and member of the Fire Advisory Board of the Institution of Engineers, Malaysia. He has a degree in Mechanical Engineering from the University of Canterbury, New Zealand and a Management Diploma from New Zealand Institute of Management. He is a Professional Engineer registered with the Board of Engineers, Malaysia and a Fellow of the Institution of Engineers, Malaysia (IEM). He spoke in many public seminars both for the insurance industry, Malaysia Fire Protection Association and the Institution of Engineers, Malaysia. Currently, he conducts courses regularly on the concepts and design in the area of Fire Engineering and Plumbing Engineering at all the IEM branches in Malaysia.
He is an active member in number of SIRIM Work Group in drawing up Malaysian Standards on plastic pipes.
NOTE: - Closing Date: 02nd December 2018 - Limited to 35 participants only
|